News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - HaioPaio

#1
I'm at Newbie status and can send PMs.
It seems to be dependent on a minimum number of posts by the sender.
It would be helpful for new members to know that limit.
I had never tried sending PMs earlier.
#2
Click at the name of the person.
A window will open and you will find "Send PM"
#3
General Tormek Questions / Re: T8 Recommendations?
January 25, 2024, 12:53:28 PM
Ken
I would prefer if you, as a moderator, would not step into the shoes of the marketing and sales persons.
#4
Nice result. Congrat.
Could you be so kind to describe what you did with the Tormek for this task?
#5
Quote from: Dutchman on November 29, 2023, 12:14:45 PMThe Adjustable Stop could be added to a self-centering Jig
"It isn't rocket science surely?"
I agree. I would not mind loosing the theoretical capability for "grinding convex edges".
#6
Two thoughts
I would not give my best knifes away to get it sharpened freehand, no matter how good this individual may be.
I would love to be proficient enough to do quick and dirty freehandsharpening for my simple knifes. Unfortunately, I'm not good enough.
On the other hand, I have plenty of time.
#7
Wood Carving / Re: Tormek will get chisels SHARP
November 22, 2023, 08:51:12 PM
hear, hear
#8
Received the invite mail 5 mins ago
#9
Ken
I'm afraid that I'm not familiar with your shaft alignment procedure. Could you be so kind to guide me to the place where it is described?
#11
Thanks for showing your helpful solution.
#12
Knife Sharpening / Re: Convexing thoughts
September 24, 2023, 08:23:21 PM
I think you could move the blue line upwards, so that it lies fully inside of the black lines.
This would illustrate the fact that the grinding wheel cannot add material to the knive.
Changing a flat grind to a convex grind with a fatter edge always reduces the height of the knife.
Grinding the flat grind to a thinner edge maintaines the knife hight, however increases the bevel hight - as you already explained.
#13
Knife Sharpening / Re: Convexing thoughts
September 22, 2023, 12:17:26 PM
I would like to keep the double stop and make it adjustable.
#14
Merlin
One more question.
Do you know a person who successfully thinned out a kitchen knife with a Tormek?
This would be a starting point, at least.
I'm using a series of flat diamond flat whetstones for that purpose and at the end the task of providing a nice finish is due.

#15
Knife Sharpening / Re: Newbie introducing recurve to blade
September 08, 2023, 10:34:47 PM
Quote from: Thy Will Be Done on September 08, 2023, 09:57:14 PMAnd what are the facts? 
No, I meant, what are your facts? Is your single personal experience opinion supported by scientific data or by experince of multiple experienced users?
I hear what you are saying, and do not have any reason not to trust you.
I'm just asking for the many others, supporting your concern.