Quote from: cbwx34 on Yesterday at 04:24:07 AMThe motor's shaft may be slipping on the rubber drive wheel
You can also use never slip, which is available from automotive suppliers. Generally used on Vee belts but ideal for your Tormek drive wheel.
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: cbwx34 on Yesterday at 04:24:07 AMThe motor's shaft may be slipping on the rubber drive wheel
Quote from: guitar_edg on May 16, 2024, 01:56:04 AM30 minutes on the 220 grit stone, and I still don't have a flat surface on the face of the chisel.
Back at it I go.
Quote from: guitar_edg on May 13, 2024, 11:22:39 PMBDay on Wednesday, so I can't open it until then
Quote from: John_B on May 12, 2024, 07:13:31 PMI do not use the paste very often and it seems to work fine
Quote from: cbwx34 on May 09, 2024, 05:19:25 PMI'm not a BESS fan... but according to this post, a 13-15 dps edge should be able to achieve a lower score.
Quote from: AusSn on May 09, 2024, 02:09:03 AMWhat is the best practice to try and ensure the KJ-45 (or similar) is holding the blade level? In other words so that for the most part the blade is perfectly horizontal. Do people use a guide or jig? Just eyeball it?
Quote from: guitar_edg on May 06, 2024, 10:13:50 PMIs there anything else I need to know?
Quote from: Ken S on May 06, 2024, 08:14:18 AMYour printed copy of the handbook should be a working book. Mine has a lot of underlining and hilighting. I note page numbers with topics in the front as well as notes in the margins.
Quote from: Sir Amwell on April 29, 2024, 08:34:17 PMIt is fairly well known I think that sharpening softer steels on CBN is inadvisable due to clogging effect.
Quote from: BaltoT on April 26, 2024, 04:32:24 PMAlso, what wheels/accessories/kits should I order with T-8 black. I will be using it for:
- chisels, including wide timber frame chisels and slicks
- planer blades
- knives (kitchen, etc)
- axes
Page created in 0.062 seconds with 16 queries.