Quote from: John_B on Yesterday at 07:13:31 PMI do not use the paste very often and it seems to work fine
Remember that the grit in the paste will wear down quit rapidly so the best technique is little and often rather than a lot and seldom.
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: John_B on Yesterday at 07:13:31 PMI do not use the paste very often and it seems to work fine
Quote from: cbwx34 on May 09, 2024, 05:19:25 PMI'm not a BESS fan... but according to this post, a 13-15 dps edge should be able to achieve a lower score.
Quote from: AusSn on May 09, 2024, 02:09:03 AMWhat is the best practice to try and ensure the KJ-45 (or similar) is holding the blade level? In other words so that for the most part the blade is perfectly horizontal. Do people use a guide or jig? Just eyeball it?
Quote from: guitar_edg on May 06, 2024, 10:13:50 PMIs there anything else I need to know?
Quote from: Ken S on May 06, 2024, 08:14:18 AMYour printed copy of the handbook should be a working book. Mine has a lot of underlining and hilighting. I note page numbers with topics in the front as well as notes in the margins.
Quote from: Sir Amwell on April 29, 2024, 08:34:17 PMIt is fairly well known I think that sharpening softer steels on CBN is inadvisable due to clogging effect.
Quote from: BaltoT on April 26, 2024, 04:32:24 PMAlso, what wheels/accessories/kits should I order with T-8 black. I will be using it for:
- chisels, including wide timber frame chisels and slicks
- planer blades
- knives (kitchen, etc)
- axes
Quote from: Ken S on April 16, 2024, 01:22:46 AMIn the absence of a T1, the T2 makes a good stand in
Quote from: Rob on April 15, 2024, 10:34:28 AMAlso what's all this talk about composite honing wheels?
Quote from: Ken S on April 15, 2024, 02:13:13 AMJohn,
Is the T2 available in Australia?
Ken
Quote from: RichColvin on April 02, 2024, 04:35:10 AMThis is still my favorite: the Tormek T-99
Quote from: AlInAussieLand on April 07, 2024, 01:29:30 PMSo I am going to add a 250mm CBN 80# Grid as soon as possibleHave you decided which one?
Page created in 0.145 seconds with 16 queries.