News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

spoke shave blades

Started by grizzz66, March 20, 2011, 07:22:20 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

grizzz66

March 20, 2011, 07:22:20 PM
hey everyone ,  just a quick question about spokeshave blades .  is there a specific jig to use for that on my tormek ? if there is i don't have it , YET !   ;)
what are you building today ?

ionut

#1
March 21, 2011, 04:58:45 PM
Hey Grizz,

You probably have the jig for spoke shaves, SVD-110, the tool rest can be used to sharpen spoke shaves.
But if you go at this link http://www.leevalley.com/en/wood/page.aspx?p=44484&cat=1,50230, as you already saved on the cap iron screw driver :), you will find a small blade holder that would allow you to use the SE-70 straight edge jig for a more precise sharpening.

Ionut

Ken S

#2
March 21, 2011, 07:23:05 PM
Good thought, Ionut.

Ken
Print
Go Up Pages1
User actions