Messages

Of course I started immidiately to search for a source of HDPP chopping/cutting boards. But the result was disappointing, I found no supplier for these boards in home kitchen sizes. Any suggestions where to look?

Thank you for this comparison. I like data based results! Great.

Drilon

No problem with Paypal in Germany.

Best regards,
Drilon

Ribbed photographic developping trays have a minimum contact area to the wheel, resist by nature to water and are much softer than steel. They also can moved around easily. If they sit on the floor, the chance of a damage if the wheel tilts is less.

Drilon

Impressive!

Dear friends, I didn't like to clean the magnet side of the T7 water trough from captured steel particles. So I sealed a strong magnet in a plastic foil (picture 1). In the trough it is held by the existing magnet of the trough (picture 2). Most of the steel particles now are collected by the strong magnet in the foil. For cleaning the magnet with the surrounding foil can be removed (picture 3) and cleaned easily outside the trough.   

Why don't you use Knife Grinders (wootz) software to set the correct angle? It is easy to use and very precise.

...snip...
This device I fixed on the standard collar with strong double sided sticky tape.
...snip...


I love innovation.  How does it work with the rotation of the standard collar?  Do you just set the projection in increments of half-turns and go from there? 

Rick

Rick, after seeing your great tool I was looking for a way that I can test this method. That was my intention to make the cheap copy. If I come to the conclusion that I like it and use it often I most probably will purchase your professional tool as now offered by Knife Grinders, Australia.

Thank you!
Drilon

...snip...
This device I fixed on the standard collar with strong double sided sticky tape.
...snip...

I love innovation.  How does it work with the rotation of the standard collar?  Do you just set the projection in increments of half-turns and go from there? 

Rick

Yes, the increments are half-turns.

Drilon

Just a short info about my economy version of the pin pivot collar.

I used a flat washer, glued on it two tubes with a high strength epoxy glue (cured at 90°C for two hours). This device I fixed on the standard collar with strong double sided sticky tape.

Works great – and can be removed if needed!

Best regards
Drilon

Hello Wootz and Rick, using a second micro-adjust to adjust the caliper is a good idea. Unfortunately it doesn't work with the T7 as the base holding the USB is 1mm too wide in diameter.
Regards,
Drilon