News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - CopperFish

Pages1
#1
Knife Sharpening / Tormek should release a jig like on the T-2 for the T-8 and T-4
April 16, 2024, 06:31:00 PM
It seems like it should be straight forward to create a knife jig like the T-2 uses that would work on the T-8. This would save a lot of time when sharpening multiple knives in a single session.

I'm sure the T-2 jig isn't out of the box compatible with the T-8 but I'm sure they could design a similar jig that would work.
#2
Knife Sharpening / Re: Knife Angle Setter "Black Edition"
March 11, 2024, 08:32:50 PM
Anyone hear anything new on a Tormek version of this? Will they be releasing it?
#3
Knife Sharpening / Re: Do I need the wide knife jig for this knife?
March 10, 2024, 04:21:15 AM
Quote from: John_B on March 09, 2024, 11:48:46 PMThis knife according to the description appears flexible. I would use the KJ-140.

Thank you!! I'll order it today. Is there a particular vendor people like over the others?
#4
Knife Sharpening / Do I need the wide knife jig for this knife?
March 09, 2024, 03:34:55 AM
I just bought this knife: https://bernalcutlery.com/products/copy-of-new-vintage-canadian-15cm-6-chef-carbon-rosewood-50s

It's 14.5" long. Will the normal knife jig work or do I need the bigger one?

Pages1