Quote from: tcsharpen on Today at 04:04:35 AMQuote from: cbwx34 on Today at 03:58:28 AMQuote from: tcsharpen on Today at 03:46:47 AMQuote from: cbwx34 on Yesterday at 10:16:06 PM(In fact, I'm not sure the spring is needed all that much.)
It may not be entirely needed, but I like that it is there. It pulls the angled section into the blade.
I don't disagree.
What I did prior to answering earlier was tighten the "Knob for locking Protrusion" enough so that the spring didn't have any affect, and found that I could manipulate the jig quite well without the spring's influence. But it is a convenient feature.
Oh yes, totally agree with this. Once locked in place the spring has zero impact.
Not quite what I meant... I just tightened it enough to negate the spring, I could still slide protrusion piece back and forth to set the distance, without the spring doing anything... then tightened it down.