Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
Quote from: Ken S on Today at 03:28:58 AMSome of the members are unsure if tomorrow's class will be part of Tormek's youtube channel. Some reassurance from you would be most appreciated.
Quote from: TireguyfromMA on Today at 05:37:17 AMPlaced my order with Sharpening Supplies for the KS-123 about five minutes after I got the email from TORMEK. The cost was $50, I thought they were going to cost more, so pleased with the price.
Will I be able to use this to set the angle on the honing wheel also?
Quote from: cbwx34 on Today at 04:24:07 AMThe motor's shaft may be slipping on the rubber drive wheel
Page created in 0.032 seconds with 13 queries.