Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Josu V, December 30, 2019, 06:51:36 PM
Quote from: Josu V on February 02, 2020, 12:03:06 PMHi.Normally there is no problems with Spanish customs... (normally)Sincerely, my only one problem is the money that I must pay in customs... Taxes: 21% (IVA), Customs Tariff: between 10 to 20%, Customs Clearance 15 to 35€. All taxes are applied to value of product and value of shipping.Any case, probably next week, the PT50A will be in my hands .Regards
Quote from: Oldhand on February 03, 2020, 08:46:46 AMThe only other thing I'd add, is especially if shipping is an issue, you're going to get 300+ tests out of a single roll of their test material (this is from memory, feel free to correct me if I'm wrong - if I recall, 300 is on the conservative side). Judge what you think you'll need in an appropriate amount of time and order enough to get you by. Shipping could be more than the reasonably priced spools.
Quote from: john.jcb on March 04, 2020, 07:30:56 PMJosh Here is a video that may be of interest to you. It is a simple DIY device for getting repeatable tension on the cord. A side benefit is that it reduces the cord you use.https://www.youtube.com/watch?v=yO7m-h-oOCQ
Quote from: van on March 04, 2020, 09:08:58 PMHi Josu V,Why did you choose the PT-50A instead of the PT-50B perhaps the degree of resolution? or other.Regards
Quote from: Ken S on March 04, 2020, 11:41:40 PMMy BESS tester is the PT50, an earlier version of the PT50B. For my use, it is quite adequate.I have no wish to replace it, however, if I was buying one today, although the PT50B is very adequate, I would opt for the PT50A with its more sensitive reading scale. Ken
Page created in 0.045 seconds with 20 queries.