News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu

Tappering off at the ends

Started by Rick, April 12, 2015, 12:10:21 AM

Previous topic - Next topic

Rick

I have no idea what I'm doing wrong. I'm working on DeWALT 13" planer blades. The re-sharpened area looks great almost the entire length of the blade, looks true and parallel. But when I get to the ends, seems that the sharpened surface tappers off right before the end of the blade. I trued the surface of the stone, I then tried with little pressure applied, I tried with slightly harder pressure..etc.. always with the same results. I tried running the blade to either edge of the stone and also to the middle of the stone but it still does the same thing! Is the jig support misaligned? I'm simply dumbfounded! Has anyone else experience this kind of result? if so, what is the solution? Thanks. Rick.

Ken S

Rick,

Welcome to the forum. You ask an interesting question. Unfortunately, I don't think we have many (any?) forum members who are really experienced with the planer blade jig. I hope you receive knowledgeable posts, however, I believe you will get better advice more quickly by contacting Tormek support directly. Their email address is: support.tormek.se
Support replies within a day or two.

Good luck, and, by all means, keep us posted.

Ken

Elden

   I noticed this problem as well when doing jointer blades with a a dry grinder (Foley  Belsaw 1055) some years ago. Don't remember if I left them that way or overcame it, too much water has gone under the bridge! I don't have the Tormek planer attachment.
Elden

mark1

Hi Rick, I also noticed this to some degree on my jointer knives. I think I was pausing longer at the end of each stroke and kind of zooming through the middle section. I adjusted that by slowing down toward the center and spending less time on the edges.

Rob

It could be:

- your knives are not straight (check with a known straight edge)
- as above for the jig (same test)
- you are applying uneven pressure at either end of the swing (adjust your finger pressure in the spots where the grind is failing)
- possibly even the USB is bent, also check with a straight edge.
Best.    Rob.