News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Sharpco

#451
Thank you.

Your reply has been helpful. :)
#452
Knife Sharpening / Re: Finishing with SJ-250
October 22, 2017, 01:39:53 PM
wootz.

Thank you so much. I will try again.

I have a question. What is the BESS result after you have used the Honing wheel?
#453
Knife Sharpening / Re: Finishing with SJ-250
October 22, 2017, 09:03:40 AM
Yes. I could get a sharper edge using the honing wheel after the SJ-250.
#454
Knife Sharpening / Finishing with SJ-250
October 22, 2017, 04:55:01 AM
Tormek said......"Since the surface left by the Japanese Waterstone is so fine, we do not recommend honing afterwards on the leather honing wheel."(https://www.tormek.com/international/en/accessories/grindstones/sj-250-tormek-japanese-waterstone/)

But in my experience, the SJ-250 finished knife is not sharp enough. There is a big difference compared to the honing wheel.

Is your experience the same?
#455
Do you feel that the results of Tormek's Honing wheel (PA-70) are sharper than paper wheels and buffing wheels?
#456
http://www.bushcraftuk.com/downloads/pdf/knifeshexps.pdf

Does the Chrome oxide compound on page 27 mean the PA-70?