I found out that DE-250 smaller than DF-250 and DC-250 during sharpening knife. I measured its diameter with a caliper and found that to be true.
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: Ken S on June 22, 2023, 07:20:03 PMSharpco,
I am pleased, but not surprised, that Tormek is providing excellent service.
Incidentally, was your wheel broken in for the photo?
Ken
PS Your knife showed the excellent bevel control I would expect from your work.
Well done!
Quote from: tgbto on June 19, 2023, 08:56:45 AMMaybe the uneven scratch pattern is due to the diamond break-in not having happened yet. I found this effect to be most noticeable on the DE, as the scratch marks left byt the protruding diamonds would stand out.
Quote from: RickKrung on November 21, 2022, 03:33:58 PM
So? What? Would you have complained if Tormek had said "up to 9.2mm? It is what it is, be happy that it does what its primary purpose is - self centering - up to 9.2mm. If you can't be happy with that, take initiative, substitute longer screws.
Rick
Quote from: cbwx34 on November 21, 2022, 04:20:15 PMQuote from: Sharpco on November 21, 2022, 05:24:10 AM
"The KJ-45 Centering Knife Jig centers knife blades up to 10 mm thick."
(https://tormek.com/en/products/grinding-jigs/kj-45-centering-knife-jig)
How???
The knob shown in the picture was fully tightened.
Easily clamped an object 9mm wide...
... I don't understand...
Quote from: WimSpi on November 21, 2022, 01:32:00 PM
Personally, I get to a maximum of 9,2 mm. But then it does not clamp optimally. Then I have to go back to 6 mm.
Quote from: 3D Anvil on November 21, 2022, 06:58:38 AM
How what? I don't understand your question.
Quote from: cbwx34 on August 11, 2022, 02:41:41 PM
The 2nd link in my signature is a website that shows every calculator I know of to date.
Quote from: tgbto on August 11, 2022, 01:29:21 PM
Then what do you mean by "the same way" ?
Page created in 0.153 seconds with 19 queries.