Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Widu

Knife Sharpening / Re: Kenjig
November 19, 2022, 06:07:10 PM
Hello , and thank you . for the most helpful answers to my question. I have only had the T8 a month and what an eye opener also not great with all the modern computer stuff good job the other half is.
what a great site this is so much info , and knowledgeable , helpful  members. I thank you once again PAUL.
Knife Sharpening / Kenjig
November 19, 2022, 11:55:05 AM
Hello everyone .  I am new to this site , so excuse me if this question is in the wrong place.  I have just purchased a Tormek T 8  a big jump from a Lansky, so I have just started sharpening knives with the T8 and read about the Kenjig to set the support bar accurately for a 30* bevel . does  anyone know what length one would have to be for a 20* bevel . that is with a 250 sanding wheel and also for a new leather polishing wheel . May i just say what a great site the Tormek community is especially for an old technology Dinasaur such as me . I hope someone can help with my question thank you ine anticipation.  PAUL.