Hello everyone . I am new to this site , so excuse me if this question is in the wrong place. I have just purchased a Tormek T 8 a big jump from a Lansky, so I have just started sharpening knives with the T8 and read about the Kenjig to set the support bar accurately for a 30* bevel . does anyone know what length one would have to be for a 20* bevel . that is with a 250 sanding wheel and also for a new leather polishing wheel . May i just say what a great site the Tormek community is especially for an old technology Dinasaur such as me . I hope someone can help with my question thank you ine anticipation. PAUL.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com