News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - saleemtaibjee

#1
Hi. I recently acquired a Tormek Supergrind 1200. I have separately acquired a BGM-100 upgrade kit.
I now have 2 options in order to reposition the universal support to a horizontal positionwhich allows for sharpening away from the wheel turning direction which I understand is better.
I can either use the entire BGM-100 kit, and fix the support to the side of the grinder (more hassle, requires some sort of base board or bench mounting), or I can use the XB-100 which is included within the BGM-100, and just mount that on to the top of the casing of the Grinder. It is plastic casing, but I understand if I use washers, this should be fine. I am probably going to opt for the on-grinder option for simplicity, unless others advise otherwise?
Thanks for your advice.