Is there a source in the US for the FVB?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / I wish I had pulled the trigger earlier
January 10, 2022, 05:41:22 PM
Many years ago I became aware of the Tormek system of sharpening. Since that time I have spent many $$$$ on different methods and tools. The results were okay but I knew that improvement was needed. I received a T4 unit 2 days ago and spent some time getting used to it. I then made an assault on my kitchen knives and was very please with the results. For what $$$ I spent in the past I could have easily saved a bunch by purchasing the unit years ago.
After some use, it became apparent a small modification would be in order. The screw needs to have a screwdriver slot to assist in snugging it during setup. My reason for the request is fat leathery fingers have a difficult time grasping it. I am considering adding one using a Dremel tool.
The only real complaint I have is the nameplate on the front of the machine was pulled off when removing the Angle Master. I can remedy the situation with some glue.
After some use, it became apparent a small modification would be in order. The screw needs to have a screwdriver slot to assist in snugging it during setup. My reason for the request is fat leathery fingers have a difficult time grasping it. I am considering adding one using a Dremel tool.
The only real complaint I have is the nameplate on the front of the machine was pulled off when removing the Angle Master. I can remedy the situation with some glue.
Pages1