News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - tim

#1
Scissors Sharpening / screws
May 11, 2022, 06:10:58 PM
Any ideas where I can find screws and nuts for gingher shears? They are left handed if that matters. Thanks
#2
Scissors Sharpening / tight
April 26, 2022, 05:27:00 PM
A friend of my wife's gave her a pair of offset fiskars fabric shears. The blades are in good shape. They are very hard to open and close but they cut just fine. Backed the screw off maybe 1/10 of a turn. They wont cut anything now. I know it has too much of a gap. ANy ideas how these can be made to work?
#3
Scissors Sharpening / scissor sharpening business
February 08, 2022, 08:38:30 PM
This may have been covered before but I have a question. Have cheap throwaway scissors killed the sharpening market?
#4
Knife Sharpening / newbie question
September 15, 2021, 03:12:33 PM
Sorry, I`m sure this has been covered. How much do folks charge to sharpen knives?
#5
Scissors Sharpening / grrr
July 08, 2021, 06:04:47 PM
Steep angles for shears kicking back with stone coming in to edge.
#6
General Tormek Questions / bench grinder speed
May 17, 2021, 08:37:02 PM
Is it possible to slow a standard bench grinder down to tormek t4 speed?
#7
General Tormek Questions / tormek xb-100
March 29, 2021, 01:48:03 AM
Anyone have the dimensions for the tormek xb-100?