Topics

I have the Tormek T-8, can it sharpen straight plunge and spiral router bits?

https://www.leevalley.com/en-ca/shop/tools/power-tool-accessories/router-bits/101862-solid-carbide-onsrud-spiral-router-bits?item=86J0208
https://www.leevalley.com/en-ca/shop/tools/power-tool-accessories/router-bits/42891-high-speed-steel-onsrud-spiral-router-bits
https://www.leevalley.com/en-ca/shop/tools/power-tool-accessories/router-bits/30163-straight-plunge-bits?item=16J0658

The DBS-22 seems to not be able to sharpen flat bits, it only goes up to a max of 150° for the point angle?

I recently purchased Japanese Knife. Unlike western knives, it has a grind so the two sides aren't parallel so I can't just half the edge angle to find the edge angle. See the side view of the blade in the photo below.
The edge is also very small, less than 1mm, so difficult to align the angle master with the actual edge
Any suggestions on how to find the correct edge angle?

Hello,
Just got the T-8.
Read through the manual. It states when sharpening knives, the "correct mounting position: ⟵a⟶" will make the bevel and the edge angle the same along the entire length of the blade. (see image from manual below).

However it doesn't explain how to calculate and set this position for various knives.
Any guides, suggestions or tips would be greatly appreciated.

Thank you.

Hello,
Can T-8 sharpen Bird's Beak Peeling Knife?
If so what technique works with such a concaved blade?

Any suggestion for a good carrying case for the T-8?