Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - RustyGunn

Hi. I have a T7 ordered today. I'm very impressed with it. I seen quute a bit of videos on it.

Well, one of the reasons I ordered the T7 is to make hollow grinds on 1.5 inch long neck knives. I'm not sure if the jigs that come with it would work though, or if I got to do it freehand.
The D2 steel is ready to use planer blades one inch tall, one-eight thick and will be 4 to 6 inches long.
Anyone here ever use a T7 as a hollow grinder for small neck knives?
By the way, I will be pre-grinding the bevels (and blade profile) on a variable speed bench grinder. This way the T7 won't have too much material to remove.

Any one making knives with the T7?