News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Jambe

#1
General Tormek Questions / MultiTool
November 01, 2013, 04:07:24 AM

Is anyone here using the MultiTool?

I plan to buy it and wonder if I should opt for the Jet 1725 ($330-3/4HP) or the Jet 3450 ($240) RPM 8" grinder? Would slower actually be better?  There is also the Porter Cable ($120) variable speed (but it is just 5.0 amp).  Just looking for suggestions.

-Doug
#2
General Tormek Questions / Bench Height
September 17, 2013, 03:53:26 AM
I haven't received my T7 (with rotating base) yet but I need to build a bench to set it on. I'm 5'-10". What would be an ideal height for the bench?
#3
General Tormek Questions / Directory of Owners
August 11, 2013, 12:00:52 AM

Just registered today, August 10, 2013. Typing August 10 just reminded me that I joined the USAF 53 years ago today!

I'm curious if there is some way to find an owner of a Tormek system near where I live--the top of Utah in Cache Valley/Logan.

I am developing a prototype tool which needs to be sharpened with more precision than I can do with a bench grinder. Either 0.083 or 0.120 mild steel.

I tried to find a spec on the width of the grinding wheel but was unsuccessful--2.25" would be ideal, since that is the width of shaping/sharpening that needs to be done--eight places.

BTW, I think Simple Machines forum software is the best.  :)

-Doug