I have a Jet 15" Planer.
What degree should you use if you mess up the original factory edge, using the SHV-320 jig?
What degree should you use if you mess up the original factory edge, using the SHV-320 jig?
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuPage created in 0.017 seconds with 16 queries.