News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - r49miner

#1
I would like to thank everyone for their input. Jeff was right to refer me to the manufacturer if he does not have my type of planer. This is what I found out, there are actually two angles on my blades. For a 15" Jet Planer Model# JWP-15CS.

Tech support recommends 40 degrees on the front side and 42 degrees on micro bevel for tip of blades.

Again thanks for the replies.
#2
I thought maybe someone would know on here, sorry my mistake.
#3
I have a Jet 15" Planer.

What degree should you use if you mess up the original factory edge, using the SHV-320 jig?