Messages

Hello , and thank you . for the most helpful answers to my question. I have only had the T8 a month and what an eye opener also not great with all the modern computer stuff good job the other half is.
what a great site this is so much info , and knowledgeable , helpful  members. I thank you once again PAUL.

Hello everyone .  I am new to this site , so excuse me if this question is in the wrong place.  I have just purchased a Tormek T 8  a big jump from a Lansky, so I have just started sharpening knives with the T8 and read about the Kenjig to set the support bar accurately for a 30* bevel . does  anyone know what length one would have to be for a 20* bevel . that is with a 250 sanding wheel and also for a new leather polishing wheel . May i just say what a great site the Tormek community is especially for an old technology Dinasaur such as me . I hope someone can help with my question thank you ine anticipation.  PAUL.