Yes be careful folks. I believe the OP was referring to deburring the chainsaw BAR not the teeth of the chain itself. You could never use a Tormek to sharpen a tooth obviously.
The Oregon jig or similar is the way to go to sharpen inside any given chainsaw tooth, observing the correct geometry, tilt angle and so on. The grinding wheel in that case is thin enough to get inside the gullet of the tooth.
The Tormek in this case was being considered as a means of dressing the edge of the chain bar. These have a tendency to develop a sharp burr through use.
The Oregon jig or similar is the way to go to sharpen inside any given chainsaw tooth, observing the correct geometry, tilt angle and so on. The grinding wheel in that case is thin enough to get inside the gullet of the tooth.
The Tormek in this case was being considered as a means of dressing the edge of the chain bar. These have a tendency to develop a sharp burr through use.