Here is another method to get your measurements. In the text there is a "Download here" to download an excel file.
https://forum.tormek.com/index.php/topic,4968.0.html
https://forum.tormek.com/index.php/topic,4968.0.html
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: cbwx34 on March 18, 2023, 02:47:01 PMI'm pretty sure you can. I learned it from jvh in this thread that the formula is a bit "generic" (for lack of a better word?). It will calculate the USB height, as long as you can figure out the Jig Diameter, and Projection Distance adjustments.
Quote from: aquataur on March 17, 2023, 02:55:47 PMtry to reformulate my question: does your software take into account that some jigs are so thick, that the projection line is shifted several millimeters up resp. out of the center? (In case of the SE-77 this has a fulcrum point at the USB, but the projection line is several cm away).
Page created in 0.012 seconds with 17 queries.