Sharpening a mortising chisel

[royaltyl]

I just bought a T-7 and proceeded to sharpen all my chisels.  I ran into a problem with a 1/2" mortising chisel.   It would barely fit into the square edge jig, not enough protrusion to get the desired 30 degree angle.  Is there a jig recommended for larger mortising chisels.  I was able to sharpen my 1/4" and 3/8"; the 3/8" stuck through just enough to get the angle.

Larry

[ionut]

Hi Larry,

I've posted an answer about this on the "General Tormek questions" thread.

Ionut