News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

flattening side of wheel

Started by jetwoodshop, May 26, 2012, 03:24:13 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

jetwoodshop

May 26, 2012, 03:24:13 AM
the only other thread on this topic refers to drilling out a truing tool that i do not have. i have a tt-50 truing jig. can i modify my truing jig to flatten the side of my wheel, or is there another method to get this done?

thanks,

james
Print
Go Up Pages1
User actions