Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Stovepipe, June 16, 2022, 01:42:59 AM
Quote from: Stovepipe on July 08, 2022, 03:36:16 AMI've attached the drip tray model along with the protective shield I had modeled. The drip tray has a grove cut into it and the shield should fit into the groove. I just sent it out to be printed and should receive next week. Once received I'll post pictures. In meantime I've posted the zip files of each so those that want can have printed.
Page created in 0.154 seconds with 19 queries.