News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu

why four facet grind?

Started by Ken S, November 13, 2022, 07:47:48 PM

Previous topic - Next topic

Ken S

This video by mrpete22 starts with a very well done illustration of the reason for a four facet grind. The initial illustration shows the common large chisel point bit. Mr. Pete explains the importance of using a smaller bit with a diameter of just larger than the chisel point for accurate drilling. The four facet point eliminates the chisel point and reduces the need for initially drilling a smaller hole.

Mr Pete is a retired shop teacher and a wealth of information. Here is the link:

https://youtu.be/cqn2VPGYA9c

Ken