Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Sir Amwell, November 06, 2022, 10:02:50 PM
Quote from: tgbto on January 10, 2023, 09:04:49 AMAre we sure though, that the support is exactly perpendicular to the side of the stone ? Because we true parallel to the support
Quote from: tgbto on June 12, 2023, 03:14:21 PMQuote from: tgbto on January 10, 2023, 09:04:49 AMAre we sure though, that the support is exactly perpendicular to the side of the stone ? Because we true parallel to the supportI tried to take measurement this weekend. On an admittedly reduced sample consisting in the two T-8s I own. I tried to measure with both a digital protractor and a machined square. Here's my take on this : though USB and inner stone wall don't seem to be *perfectly* perpendicular, they are perpendicular within the precision of the digital protractor, and meet at an angle that is ever so slightly obtuse on both machines. About barely enough to let light shine through the tiny gap between the square and the USB on the side opposite to the housing. So as far as I am concerned, I'll consider those two are perpendicular.
Page created in 0.013 seconds with 19 queries.