Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Nico, October 21, 2022, 10:40:41 AM
Quote from: Ken S on October 29, 2022, 02:02:39 AMTormek's suggestion of lifting the support bar and moving the TT-50 diamond to be able to travel inward is fairly new. [...] I suspect the lift was started because of chipping complaints from users who set the TT-50 to cut too deeply. [...] By making very shallow cuts and not needing to lift the support bar, there is no problem with misalignment. [...]
Page created in 0.022 seconds with 20 queries.