Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by tim, April 26, 2022, 05:27:00 PM
Quote from: tim on April 26, 2022, 05:27:00 PMA friend of my wife's gave her a pair of offset fiskars fabric shears. The blades are in good shape. They are very hard to open and close but they cut just fine. Backed the screw off maybe 1/10 of a turn. They wont cut anything now. I know it has too much of a gap. ANy ideas how these can be made to work?
Quote from: tim on April 29, 2022, 04:01:55 AMHappy to report after straightening a little and sharpening, success. My wife who knows her way around fabric and sewing thinks her friend will be happy. Thanks guys for the ideas to try.
Quote from: tim on April 30, 2022, 03:45:05 PMDon't laugh but my bench is an old door. Put each blade in the lock bolt hole, added very lite pressure. Not a go to process but it worked.
Page created in 0.016 seconds with 19 queries.