Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by AndrewEv, May 16, 2018, 05:38:15 PM
Quote from: cbwx34 on May 17, 2018, 03:30:16 PMI had to look these up... know nothing about them.If I found the correct info...apparently it takes a special machine to actually sharpen them.But I did find a couple of videos, indicating they can be "touched up" on a flat surface... if not in too bad a shape?One that might be of interest...https://www.youtube.com/watch?v=HlvZNYrGsFM... the sharpener uses a flat diamond wheel for the task. So maybe the side of the new diamond wheel might be up to it?(But from what I read, if it needs more than a "touchup", a special machine/wheel is needed).Feel free to tell me otherwise... no 1st hand knowledge here.
Page created in 0.016 seconds with 19 queries.