News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Just Got A T-4 and a 1x30 Belt Sander, Advice Needed

Started by jasonstone20, September 01, 2020, 06:00:13 AM

Previous topic - Next topic
Print
Go Down Pages 1 2 3 4
User actions

jasonstone20

#45
February 14, 2021, 05:13:24 AM
Oh, ok.  Thank you, I will try that out.

jasonstone20

#46
February 14, 2021, 05:16:39 AM
For clarification, the knife I was talking about were the center clamping worked was the Spyderco PM2.  Were would a good place to put the clamp on that blade? 

jeffs55

#47
February 14, 2021, 02:31:16 PM
Imagine a line extending along the bolster and attach the jig so that one edge of it is parallel to the bolster if the bolster was an extended line. That is how I would attach it.
You can use less of more but you cannot make more of less.

cbwx34

#48
February 14, 2021, 05:40:40 PM
Quote from: jasonstone20 on February 14, 2021, 05:16:39 AM
For clarification, the knife I was talking about were the center clamping worked was the Spyderco PM2.  Were would a good place to put the clamp on that blade?

For a specific knife I'm sure that's fine... I thought you were talking about knives in general.
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)
Print
Go Up Pages 1 2 3 4
User actions