News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

3D-printable pivot collar for Tormek knife jig 12mm

Started by Leap, May 01, 2022, 10:31:20 PM

Previous topic - Next topic

Leap

Hello again,

I share with you a pivot collar that can be 3D-printed that will work with SVM-45 - 12mm.

https://www.printables.com/model/188651-tormek-pivot-collar-12mm

ArtOfSharp

Nice work, thank you!

However, i do have a question...

How would a 3D printed screw (included in the files) compare to an off-the-shelf screw/bolt?

Have you tested it's strength to hold position?
And, have you tried to find an off-the-shelf screw/bolt and tested that against the 3D printed one?