I am new to knife sharpening with the knife jig and it slipped when I got done to the heel of the blade on one side. So I have a nice even bevel along the edge until I get to the heel. At the heel, the scratch pattern is twice as wide. I corrected the bevel, and tightened up the support, and the bevel looks great. Except at the heal where I have the wider pattern.
I figured this can be sanded out but wanted to know if there are any tricks to use. The wheel I started with was a 180 grit CBN. I finished up with a 1000 CBN but still have these 180 scratches above the 1000 bevel. It's my own knife but it looks so bad.
Thanks
I figured this can be sanded out but wanted to know if there are any tricks to use. The wheel I started with was a 180 grit CBN. I finished up with a 1000 CBN but still have these 180 scratches above the 1000 bevel. It's my own knife but it looks so bad.
Thanks