Thanks for that. I just wanted a rough starting point. With the design I have in mind the shaft will be a seperate screw in item so length could be altered easily at the expense of new material.
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: pipen on March 04, 2020, 05:35:04 PMFinaly made one, didnt have time to test.
Got lot of ideas on internet, it is adjustable for long and mid size knifes. Any sugestiones?
Quote from: RickKrung on April 25, 2025, 05:03:30 PMWhy in the world would anyone use any wheel dry on a Tormek?
There seem to be a number of professional knife sharpeners on YouTube that do.
Page created in 0.045 seconds with 16 queries.