News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Daniel

#1
Hello everyone, sorry if this has been asked before, but I couldn't find it.

This is my first forum post ;D . I aquired a T-8 before christmas because I couldn't deal anymore with hand sharpening my collection of hand tools. It's already much bigger than I imagined and it keeps growing... Insanity! Oh, that and also because I wore down to the bare steel a full set of 220-600-1200-8000 DMT diamond coated plates in 3 to 6 months depending on grain size. True story, I swear that T10 steel eats diamonds for breakfast :o (Rust is its kryptonite, though).

So, the Tormek sounded like the most reasonable solution for dealing with those stubborn alloys, and I am oh so happy to say that this machine truly delivers. I don't think I could be any more satisfied with my purchase. It took me quite a while to decide and, living in a very corrupt and underdeveloped country, surely you can understand why I was hesitant on such a relatively-high investment. All my fears were forever dismissed after a couple of hours operating the T-8. Worth every single penny/cent.

I couldn't help but to soon notice a particular need/convenience, maybe. At this moment in time, most of my work is done with hand planes, mainly bevel-down planes. When I sharpen my planes by hand, I usually rectify the main bevel with a very aggresive/coarse abrasive, let's say 220 or under, at 25 degrees. Then I work my way up with very few passes on progressively finer stones, to establish a 30 deg. microbevel.

And here comes my observation: In my neverending quest to optimize workflow/time, wouldn't it make sense for my particular case to buy a secondary universal support and leave both "fixed", one at 25 deg for the stone and the other at 30 deg for the leather wheel? Or even, regardless of the micro-bevel, just leave both at the same recommended anglefinder setting? Since the stone and the wheel have different diameters, setting the precise micro-adjust setting when switching between stone and wheel, taking out the bar and inserting it in the other postion, etc. is what I spend most of my time while working with my T-8. Wouldn't the results be instantly repeatable if I set always the same projection of the blades out of the SE-77 jig? In my mind it sounds like a considerable time saving every time I need to resharpen a blade... which is all the time ::)

Thought I should ask before purchasing anything else, because I am often quite obtuse in my thinking and surely more experienced users will identify the flaws in my logic. Thanks!