Cool, thanks! Hope to check it out soon..
Seems to fit nicely
Seems to fit nicely
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: wootz on October 23, 2019, 08:05:37 PM
A word on home-made FVBs.
4 months ago we started CNC machining the FVB base, and have tolerances tight.
If your self-made FVB does not have the base of the same thickness as ours or legs in the wrong position, you will be getting less accurate results, and all the man-hours we've put into this software improvement will be wasted as you will not be getting better deburring and sharpness with it.
I'll be stopping making custom applets for home-made FVBs because of that, because formulas by themselves will never match the algorithm fine-tuned to our particular FVB make.
Page created in 0.013 seconds with 16 queries.