News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - donaldeverett

#1
See attached.  How do I get to the 20 angle I need.  I cannot figure out how to manipulate the tool and jig to get to the grind angle.
#2
Wood Carving / Pfeil 25/10 Backbent Gouge Sharpening
October 27, 2020, 01:00:13 PM
I need help on how to sharpen this gouge.  I cannot find any type of setup or jig that will allow me to sharpen the tool.  I have tried multiple projections and setting and none will allow for a 20 degree approach to the wheel.  Can someone send a picture or setup and jig to use?