Topics

What is the minimum length that a chisel must protude from the SE-76 Square Edge Jig in order to grind properly?  I seem to be unable to get a 90 degree grind by inserting the tool per instructions.  I was wondering if the the length has anything to do with that?

Thanks.

Just purchased a T7.  Is it normal for the honing wheel to have a wobble?

A couple of weeks ago I purchased a T7.  I have a couple of questions regarding the set up of jointer/planer blades. First of all, when the manual talks about "cutting depth" what do they mean?  Is it the amount of steel removed from the edge of the blade?  Secondly, when doing the second planer blade, do you need to go through the entire set up again or can you just put the blade in at the setting form the first blade?  Just thought of a third question.  I have read in the posts that you can remove the limiters for doing longer planer blades.  How is this done?
Thanks, "Flyer"