News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Dougie

#1
Hand Tool Woodworking / Custom drip guard
October 05, 2022, 12:48:44 AM
I want to share pictures of a drip guard I just finished for my T-8.  I love the machine, my only complaint about it is that wide blades tend to cause water to run off the edge onto the machine housing, and then on to the benchtop.  This drip guard sits very close to the stone (less than 1/16") so any water gets wicked back to the basin. 

Tormek: PM me if you want the patent rights  ;) ;D