News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - schipperke

#1
General Tormek Questions / Repair SJ-200 Stone?
December 04, 2019, 03:19:07 AM
My SJ-200 has a small chip on sharpening surface at edge of stone.  Is there any material to be had to fill in the chip?  Blade catches the chip, and wondering if there is any material to fill it, that would just wear down along with stone.  Maybe another solution would be rounding the edges of the chipped portion?  It's about 4x3mm area and maybe 1.5mm deep.
#2
General Tormek Questions / New T-4 , Disappointment
September 07, 2019, 02:05:09 AM
So I get the machine setup and talk about noisy.  I spent couple hours trying to diagnose.  Took off the leather wheel, roughened the drive wheel just a bit appears good. Removed the stone shaft, looks good and put a bit more lithium at the bushings.  Problem appears to be when the stone is installed.  It makes a terrible racket, but if I jab at the stone with my palm a few times it will then run quiet.   The thing will though soon go back to the noise, I can palm the stone (not stopping it, just applying quick pressure a few times) and noise will stop.  If I'm lucky and noise does not return during use, it always reappears if I stop then restart. 

I removed stone and put on the spacer and stropped some things, the noise did not appear when doing this, so I think it's related to stone installed problem.

Any advice?