News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Rick

#1
General Tormek Questions / Exact Arbor Size T-7
May 14, 2015, 10:24:30 PM
I would like to know the exact arbor size of the T-7? Thanks
#2
Planer Blade Sharpening / Tappering off at the ends
April 12, 2015, 12:10:21 AM
I have no idea what I'm doing wrong. I'm working on DeWALT 13" planer blades. The re-sharpened area looks great almost the entire length of the blade, looks true and parallel. But when I get to the ends, seems that the sharpened surface tappers off right before the end of the blade. I trued the surface of the stone, I then tried with little pressure applied, I tried with slightly harder pressure..etc.. always with the same results. I tried running the blade to either edge of the stone and also to the middle of the stone but it still does the same thing! Is the jig support misaligned? I'm simply dumbfounded! Has anyone else experience this kind of result? if so, what is the solution? Thanks. Rick.