News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Pargame

#1
Hello, I bought the mb-102 to remove the burr on my knives with precision but I have a problem with it. even when tucking in the constants, I roll my edges in the places where I have the belly of the knife. I tried lowering the setting by two degrees. It's better but still not perfect. Do you have a solution/technique to do it correctly? the impression that this system is only useful on straight blades without curvature otherwise the angle changes by raising the knife to follow the curve.. Thanks for your help