News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - dgendrud

#1
Knife Sharpening / Knifegrinders vertical base software
November 21, 2022, 08:27:18 PM
Hello,
I have a Frontal Vertical Base from Knifegrinders, but have lost the angle setting software for it due to a Windows OS update.  I have not been able to get a response from knifegrinders after trying their support email several times.  They confirm receiving my support request every time, but never respond with how to get another copy of the angle setting software.  Is there any source for downloading this software?  Just hoping someone here can help with this.
Regards,
Doug Endrud
Prescott, AZ