News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Santacarver51

#1
Wood Carving / Re: Learning to use the jigs
February 28, 2019, 09:25:28 PM
I can snap some pictures later.  Hopefully you or someone in the community can steer me in the right direction.
#2
Wood Carving / Learning to use the jigs
February 28, 2019, 06:20:31 PM
I am a new owner of a T4.  I have been using the knife jig and the small knife jig.  As I use the angle master I find the angle I want is 30 degrees.  As I set the guide I cannot get the Knife to sit at the 15 degrees indicated by the angle master.  It appears that the length of the adjustment rod is too short to get the knife "flatter" on the wheel.  I have watched the video several times and have practiced on a few old knives, but I am not sure what I need to do to insure I am at the right angle.