Hi Ken - good information - I took delivery of an SB-250 just yesterday so it looks
like I have a learning curve ahead of me.
Lou
like I have a learning curve ahead of me.
Lou
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: cbwx34 on October 17, 2017, 02:15:13 PMQuote from: ega on October 17, 2017, 11:43:34 AM
....
Incidentally, I have seen one complaint that the EzyLok nut could only be removed by the use of a monkey wrench.
I encountered this yesterday - I wanted to remove the stone in order to see what the gap was next to the water trough and machine housing (T-8) since I was getting a bit of water running down and filling the SB. I could not remove the nut - even tried channel locks with no success - I just gave up.
Suggestions anyone? My T-8 is about a week old.
Edit: I just wanted to add that I do realize it's a reverse threaded nut - I was turning "righty loosy"
Lou
Page created in 0.204 seconds with 16 queries.