I gave the customer his blades back free of charge so he could send them off to be done or buy new ones since they are cheaper to buy new. I no longer do planer blades.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: SVM-00 Small Knife Holder
June 06, 2013, 05:09:20 AM
I just ordered one from Amazon.com, I'll have it tomorrow.
#3
Planer Blade Sharpening / Re: Mixed feelings about svh-320 so far
June 06, 2013, 02:30:50 AM
I tried sharpening a set of planer blades for a customer (I own a small sharpening business for which I bought the attatchment) went ahead and bought the blackstone because the standard stone was too slow. I spent another 3 hours and still couldn't get them sharp. The planer blades were flat and grinding the concave edge was just too time consuming to make a profit.
Pages1