News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Chrit

#1
Planer Blade Sharpening / Delta 12 1/2 " planer blades
February 10, 2008, 08:28:58 PM
I have a Delta 12 1/2" planer and I talked to Jeff at The tool Show in Novi Mi. After I explaned the I couldn't grind my blades on a Tormex grinder, jeff Told me to pull the roll pin out of the fixture. This solves all the problem for length grinding. Perhaps we should listen to Jeff a bit more.  This saves me about $200 / year on blades. Thanks Jeff :)